HyperCyl HPI Inline Series cylinder - pneumohydraulic
Exit

HPI SERIES


LIMITED LIFETIME WARRANTY*

The Inline “HPI” series cylinder provides a reduced overall cost and minimizes the footprint of the power unit within your application versus HPX and HPS. The “HPI” is a totally self-contained, single-piece power source ideally suited for a wide variety of Assembly and Forming applications using only two (2) pneumatic valves for operation. Available from 1-Ton to 200-Tons and up to 16.00″ stroke, and 2.00″ power stroke (depending on force required and application specifications).

  • AVAILABILITY: 4-6 WEEKS STANDARD, EXPEDITE AVAILABLE
    (CALL FOR SPECIFIC AVAILABILITY)
  • MODEL: HPI-XX-X.XX-X.XX-FH-XXXX

  • Single component system
  • Quickest series of the line-up
  • Linear Transducer compatible (LTI only)
  • Total strokes up to 16.00” [400mm] using 2.00” increments
  • Power strokes up to 2.00” [50mm] using 0.25” increments
  • Greatest force per dollar investment
  • Single unit, no hydraulic lines
  • 670 lbs. – 400,000 lbs. [3kN – 1779kN] using 30 to 100 PSI shop air [2.1 – 6.9 bar]

























RELATED OPTIONS

(LTI) EXTERNAL LINEAR TRANSDUCER

Low Voltage Linear Transducers – VIEW
Magnetostrictive technology with Auto Tuning, non-contact, wear free, Analog, Digital, SSI, Pulse, CANopen, Profibus and Quadrature output, .0001″ resolution capable, 7-pin connector/cable. NOTE: Non-Rotate option required for addition of LTI.

-Resolution: 0.66A
-Non-linearity: +/- 0.02% over full scale
-Repeat-ability Resolution: min 2m
-Sampling Rate 2KHz
-Operating Voltage 24Vdc or 15Vdc

(LC) LOAD CELL

Strain bridge design load cell. Load cell O.D. matches drive unit ram O.D. for a compact, integrated design. Mini Brad-Harrison style four 4-pin connector. Signal conditioner is required.

-Rated Output: 2mV/ V
-Combined Error: 0.25% of full scale
-Non-repeatability: 0.05%
-Zero Balance: 1%
-Excitation Voltage: 10VDC
-Maximum Load: 200% of full -scale (ultimate) / 150% of full scale (safe)

(BSPP) PNEUMATIC PORTING

Pneumatic porting available to order in BSPP porting. All pneumatic ports (4).

Porting of “NPT” is standard.

(AL) MECHANICAL ROD LOCK

The “AL” Rod Lock option is a locking device installed on the head end of the cylinder that provides a positive locking of the cylinder rod when air is removed from the lock. The locking action is designed where safety considerations require positive locking of the tooling/actuator when air pressure is removed from the circuit. The rod lock option is available for all 1 through 30 ton HyperCyl® cylinders. Rod Lock – 60 PSI minimum air pressure required.

(NR) NON-ROTATE

Utilizing the flats on the external work rod, the Non-Rotate option provides a mechanical non-rotate rod/adapter plate for Anti-rotate.

Included: NR plate, NR rod, NR/FH head and fasteners.

(S) NON-STANDARD ROD END

The cylinder rod end can be modified to adapt to customer tooling, die plates and/or just about anything else that is required. Please make your request known during the quoting process.

Standard– Female, imperial thread.

ACCESSORIES